New transmission mount now bad vibration in drive at full stop only

New transmission mount now bad vibration in drive at full stop only 5 Answers

I hand new inner and outer tie rods put on my 2001 S 10 now the front drive shaft u joint is binding up on the bell housing of my transmission, why? Anybody know??? 2 Answers

I have a 2001 s 10. I have had everything under the front end replaced, my last step was inner and outer tie rods, Now while in reverse with the wheel cut left or right, my front drive shaft is bin...

Was rolling in 5th gear going 60, heard aloud screeching noise and it threw us forward in the seat and slowed it immediately to about 40.I pulled off to the side of the road and smoke was coming from under the truck.I looked around and couldn't see anything visibly wrong.I started it up again just fine and started rolling in 1st gear, then I tried to shift to 2nd the truck just stopped and wouldn't go into any gear.At this point the truck will start but when I let the clutch out, it dies(in neutral). Had to remove my drive shaft to be towed on towrope because it wouldn't roll smooth in neutral. When the engine is running now I don't feel any vibration through the gearshift anymore like how I used to before it broke down. What could it be? 3 Answers

Was rolling in 5th gear going 60, heard aloud screeching noise and it threw us forward in the seat and slowed it immediately to about 40.I pulled off to the side of the road and smoke was coming from...

rough running only at high speed 1 Answer

My 2003 chevy S10 4.3 liter V6 runs rough only at high speed.(highway speeds). it seems like it wants to go, but dosen't. runs fine at lower speeds. Fluids are all full, I added cleaner thru the fu...

S10 mount for the starter 3 Answers

I have a 1995 s10 automate 2.2 and the question I have is can you buy a starter mount for it??? It is contacted to the transmission can you buy just mount or do you have to buy a new transmission o...