20O2 chevy express 1500, 5.7 No spark. Plugs, coil, ecm module on coil bracket and crank angle sensor replaced. Ecm1 fuse blown 3 times trying to start. Replaced them and fuel pump relay under hoo
There is power up to ignition switch
No juice to engine. Starter was
acting weird a few days before.
But it cranks fine now, just no juice
to engine. Maybe harness or starter?
Crank angle sensor stated shims might be needed due to abnormal front crank bearing wear, so I used them. 148,000 miles. Harness, Starter solenoid or ignition switch. Not much left but alternator. Going to try to sell it after I fix it Too hard to work on, seems I bought a lemon.
Everybody says fuel pump is bad? It has no spark. Fuel pump cause a no spark? I am not sure.
either ignition module .. not sure. if ecm fuse blown, look for shorted wiring first.
Found sparking from main harness to A stainless line like transmission line. The plug from back of alternator runs into this group of wires. Cant work on it too cramped need to unhook more so can pull it thru. Might be easier to just replace the harness than fix it, or pull it off then repair it... Im just a shade tree mechanic anyway.
Ok so I unhooked stuff to pull it back enough to find a salmon colored wire exposed, was arcing off onto oil dipstick tube like a small sparkler. I now have power to the coil, ecm and Crankangle sensor. Should start but it doesnt. When I hook up code reader it says check connections. Then goes blank. When I turn on ignition it has to reflash memory in computer bios ? 10 minute wait or when security light goes off. Security goes off in bout 15 seconds.
Looking for a Used Express in your area?
CarGurus has 6,618 nationwide Express listings starting at $2,950.
Search Chevrolet Express Questions
Are you a UK consumer? CarGurus now has a discussion forum in the UK.
Chevrolet Express Experts