F150 clutch issue
2000 Ford F150 2wd, manual trans, grinds and
hard to put into reverse, once you start going,
gears easily shift, however when going to stop, and
clutch is depressed, it still tries to pull, like it's still
in gear. Is this a slave cylinder issue?
Check the fluid in the clutch master cylinder first, make sure you pull out the rubber seal cup, I have seen people just put fluid right on top of it. If it is low then that could be your problem, you may ave to bleed the system, if it is full and makes good pressure then it most likely is the salve cylinder, but if it is I would replace both the slave and master as a set, just due to the age. If I remember right I believe that you have to remove the tranny to gain access to the clutch slave cylinder and if that is the case you better do the clutch while your there.
I have checked the fluid, bled the system etc. I know that I do have to pull tranny. Just wanted to get another opinion if the slave cylinder sounded right. Thanks alot for your info.
Search Ford F-150 Questions
Ford F-150 Experts
Find great deals from top-rated dealersTMSearch
Related Models For Sale
Used Cars for Sale