High beams work except low beams?
May just be both low beam bulbs are out. Can test with a test light to be positive that is the problem or just buy low beam light and replace if it works most likely other one needs to be replaced also.
Low beam works but when put on.high beam light go off on driver side
1st: Pull Left side Headlight assembly. (Careful, do not force hard) 2. Test both headlight bulbs for continuity. Rpl if bad. 3. With assembly still removed, re-attach feeder line, check for high and low lights. If OK, reassemble & finish; if not 4. Pull inside eng compartment cover off of fuse and relay 'box'. 5. Find Owners manual, locate pg 5-109 to reference fuse 12 and location of relays LO BEAM & HI BEAM. (Note both relays are same part number), Check fuse 12. 6. Swap relays, try to ck if Hi BEAM relay is bad. May need to ck continuity or voltage. If any relay is bad, replace with OEM part (found on e-bay and/or Amazon). Aftermarket part not recommended. 7. Replace with proper bulb or relay, as appropriate. Retest. If good finish. If not consult with dealer. Note: My 2008 Uplander had a 'bad' low beam bulb, at first sight, the bulb looked 'good', but cked with voltmeter and it was not. Best tool for the job is a reliable voltmeter for continuity tests. Have fun.:)
is there a fuse just for low beams?
Looking for a Used Uplander in your area?
CarGurus has 816 nationwide Uplander listings starting at $1,300.
Search Chevrolet Uplander Questions
Chevrolet Uplander Experts