I am going to change my front wheel bearing on my 2003 grand am, can I re-use the bearing nut

Asked by May 24, 2016 at 05:55 PM about the 2003 Pontiac Grand Am SE

Question type: Maintenance & Repair

1 Answer

96,575

That all depends on the kind you have, if you have the kind that has nylon thread holder or is staked into place then no it must be replaced with a new nut, the only one that is reusable is the castle nut that uses a cotter pin to hold it in place.

1 of 1 people found this helpful.

Your Answer

Add photo

Related Questions

Search Pontiac Grand Am Questions

Pontiac Grand Am Experts

#1 tenspeed
tenspeed
Reputation 7,710
#2 John Saffrahn
John Saffrahn
Reputation 1,600
#3 Tom Demyan
Tom Demyan
Reputation 1,460
View All

Related Models For Sale

Used Pontiac Grand Prix
26 Great Deals out of 2,812 listings starting at $1,995
Used Pontiac Firebird
13 Great Deals out of 756 listings starting at $3,490
Used Ford Mustang
694 Great Deals out of 44,971 listings starting at $750
Used Chevrolet Camaro
347 Great Deals out of 31,219 listings starting at $2,500
Used Pontiac GTO
6 Great Deals out of 483 listings starting at $6,950
Used Chevrolet Malibu
1,125 Great Deals out of 78,643 listings starting at $2,500
Used Chevrolet Impala
595 Great Deals out of 35,247 listings starting at $899
Used Pontiac Bonneville
3 Great Deals out of 536 listings starting at $1,799
Used Honda Civic
862 Great Deals out of 85,137 listings starting at $500
Used Toyota Camry
1,197 Great Deals out of 84,710 listings starting at $750
Used Chevrolet Cavalier
4 Great Deals out of 982 listings starting at $695
Used Jeep Grand Cherokee
1,095 Great Deals out of 73,390 listings starting at $1,200

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.