How do you know if the throttle position scencer or iginion module or is it out of time?
2 Answers
CamaroCollector answered 2 years ago
Have a scan done to check for sensor condition or component failure. When was the last time the fuel filter was changed? Clean out throttle body.
tennisshoes answered 2 years ago
Do a computer scan first, fix the problems listed, then reset the ECM, after all that is done it should start and run, then drive it as you normally do for about 20 minutes, during this time the ECM is relearning the vehicle and your driving habits, that should clear up your problems.
Your Answer
Related Questions
-
How do you know if the throttle position scencer or iginion module or is it out of time? 2 answers
It would shutter when giving gas ,it would run rough till warmed up then got worse now it won't start at all now .
2002 Jeep Grand Cherokee Limited
-
Maintenance & Repair
-
How do I know if my drive train, rear end or transmission is going out on my 2003 jeep grand cherokee 3 answers
my 2003 Jeep Grand Cherokee does a couple of weird things, 1) back tires seem to spin when I take off sometimes, not every time. 2) there has been a god awful metal to metal grinding noise somewhere...
2003 Jeep Grand Cherokee Laredo
-
Maintenance & Repair
-
Has anyone experienced arcing plug wires that look like light rope!!?? Opened my hood the other night, service light under hood is out, several of my plug wires looked as if you could see current running thru them! I kid not!! When I moved them around they would begin "flowing" like light rope... Recently I had a mishap with a large deer! It has been running rough since! The plug wires are only 3 months old! Are they just really cheap wires or do I have some weird elec problem? Incidently the batt keeps going dead when it sits for a week. Check engine light is on of course!!! HELP...... 3 answers
The alternator and battery check good,had a complete tune up 3 mths ago.....
1997 Jeep Grand Cherokee Orvis 4WD
-
Maintenance & Repair
-
1999 Jeep Grand Cherokee 4.0,,,4x4......My emergency brake is sticking,I am sure its sticking because it will not move in DRIVE or REVERSE without a decent accelleration and also my brake light and abs lights come on about 5 minutes after starting it up.This all stems from a tow truck driver in the winter,wrapping a tow strap around my rear passenger axle to winch me out of the ditch!!I noticed some lines (brake lines or whatever) also strapped to my rear passenger axle..Is it possible that one or all of those lines got pinched or something during the process??Any suggestions or clues what to do are extremely appreciated!!!Thank you in advance!! 1 answer
Its obviously a V6...Please help!!!And quick!Its my only means of transportation and I start a new job on Monday!!It has actually done this since the day he pulled me out,its just getting worse where ...
1999 Jeep Grand Cherokee Laredo 4WD
-
Maintenance & Repair
-
1999 Jeep Grand Cherokee Laredo that has weak air flow from the vents. You can hear the blower motor running but barely blows out of vents whether its on AC or heat. What can cause this? 2 answers
We have checked to see if it was the cabin air filter but one was never installed. Came from factory without one. Saw no trash inside or blocking where it goes. Then we removed glove box and removed...
1999 Jeep Grand Cherokee Laredo
-
Maintenance & Repair
Shortcuts
Search Jeep Grand Cherokee Questions
Jeep Grand Cherokee Experts
| #1 |
|
inuevafreak
Reputation
2,090
|
| #2 |
|
Tom Demyan
Reputation
1,890
|
| #3 |
|
thejeepdoctor
Reputation
1,750
|
Related Models For Sale
Used Cars For Sale
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.