P1685 code fix
I got 2000 jeep grand Cherokee with p1685
code, which you get by turning key off on 3
times look at odometer it will show code,take
both battery cables off zip tie together first 5
minutes or so put back on ,no key light starts
right up, it will reset the computer and may take
40 plus times to program back in just by
starting and driving but it works!!!!
This means that your jeep did not recognize the key that was placed in the ignition. This can happen for a few reasons. Trying to start the engine with a key that is not programed to your jeep or a key that does not have a transponder chip Trying to start the engine with more then one transponder key on the key ring. Failing transponder chip in the key. You may need a need Key...
So had mew key made and programmed and still having SKIM light issue. Any other ideas?
If it doesn't correct itself you may have to bring it to a person with a scanner that can reprogram keys for you
If it doesn't correct itself you may have to bring it to a person with a scanner to have them reprogram keys
Could the ignition switch be bad
have you checked the evic. if you have a overhead consul with the ignition of press and hold the c/t and reset buttons simultaneously and while holding them switch on the ignition. if you get a J1850 message your can bus has a fault causing the skim light to illuminate..
Looking for a Used Grand Cherokee in your area?
CarGurus has 76,615 nationwide Grand Cherokee listings starting at $900.
Search Jeep Grand Cherokee Questions
Jeep Grand Cherokee Experts