Crankshaft position sensor
I coded crankshaft position sensor replaced
the sensor. Now I lost spark if the sensor is
not seated correct would that be y I lost
It could cause loss of spark if the sensor is not reading properly it must be all the way in
How sure r u of this that starter was a bitch I really don't want to pull it again..it popped like it seated when I put it in
Look at it with a mirror if u have to to see its in properly. And yes this will cause it not to start
Or the harness is worn, or a bad connector, The CKP sensor should be sending an AC voltage square wave signal when engine is cranking. Check it with a multimeter IF, you have one... Inspect the harness before pulling the sensor again.
Looking for a Used Sierra 1500 in your area?
CarGurus has 58,731 nationwide Sierra 1500 listings starting at $1,599.
Search GMC Sierra 1500 Questions
Are you a UK consumer? CarGurus now has a discussion forum in the UK.
GMC Sierra 1500 Experts