1991 ford ranger 4x4 2.9L theres brake fluid on the bell housing when clutch is engage im thinking its the slave cylinder going bad, is there any easier way to remove the slave from inside of the bell

Asked by Dec 21, 2013 at 06:22 PM about the 1991 Ford Ranger Custom Extended Cab 4WD SB

Question type: Maintenance & Repair

1 Answer

7,785

Look up "Chilton's Repair Manual" for your vehicle and they might tell you if there is. You are looking for "Clutch Slave Replacement" or close to that in wording.

Your Answer:

Ford Ranger Experts

  • #1
    tennisshoes
    Reputation
    1,630
  • #2
    F_O_R
    Reputation
    1,110
  • #3
    Bob Beaman
    Reputation
    1,050
View All

Related Models For Sale

Used Ford F-150
2,300 Great Deals out of 208,483 listings starting at $1,300
Used Chevrolet S-10
7 Great Deals out of 874 listings starting at $1,500
Used Dodge Dakota
79 Great Deals out of 3,045 listings starting at $1,495
Used Ford Mustang
266 Great Deals out of 37,716 listings starting at $1,350
Used GMC Sierra 1500
712 Great Deals out of 60,946 listings starting at $1,395
Used Jeep Wrangler
226 Great Deals out of 16,663 listings starting at $3,000

Used Cars For Sale

2011 Ford Ranger For Sale
33 Great Deals out of 697 listings starting at $3,488
2010 Ford Ranger For Sale
12 Great Deals out of 355 listings starting at $4,450
2009 Ford Ranger For Sale
5 Great Deals out of 232 listings starting at $3,995
2008 Ford Ranger For Sale
22 Great Deals out of 337 listings starting at $2,095

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.