lots of water in gas how do I get to run again.

Asked by May 14, 2015 at 07:21 PM about the 1993 Dodge RAM 150 2 Dr LE Standard Cab SB

Question type: Maintenance & Repair

2 Answers

100,655

Siphon out as much as you can, put in at least 5 gallons of good fuel with a can of gas dryer mixed in, locate the fuel return line from the engine and locate it over a bucket. Turn the key on, wait a few seconds then turn it off, check the bucket, if there is then cycle the key like that until the fuel that comes out in the bucket is all fuel without water mixed in it, put the return line back on and attempt to start it, you may have to crank it over a few times to clear the injectors, but if everything else is in order then it should fire and run, it might run rough for a little while. If you don't get any fuel in the bucket then it is a good chance that the water has ruined the in tank fuel pump? HTH

100,655

After it is finally running good fill the fuel tank with good fuel and add some StaBil Marine to the fuel tank, that should take care of the water problem.

Your Answer

Dodge RAM 150 Experts

  • #1
    Jimmy_Massung1
    Reputation
    390
  • #2
    Rowefast
    Reputation
    190
  • #3
    COMETGUY61
    Reputation
    130
View All

Related Models For Sale

Used Dodge Ram 1500
353 Great Deals out of 10,728 listings starting at $1,500
Used Dodge RAM 250
21 listings
Used Ford F-150
2,304 Great Deals out of 183,573 listings starting at $699
Used Dodge Ram 2500
162 Great Deals out of 4,955 listings starting at $2,499
Used Dodge Dakota
114 Great Deals out of 3,708 listings starting at $1,000
Used GMC Sierra 1500
877 Great Deals out of 65,113 listings starting at $2,495
Used Ford F-250
471 listings starting at $4,000

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.