Where are the Oxygen sensor and coolant temp sensor located on a 1992 5.8 bronco?

Asked by Oct 09, 2013 at 04:25 PM about the 1992 Ford Bronco XLT 4WD

Question type: Maintenance & Repair

1 Answer

6,805

The 02 sensor would be mounted about 3 inches up from the cat convertor. You'll have to get to it from underneath. You'll need a special tool to change them too. Any good autoparts store should have one if you don't already. . The coolant sender on your '92 351(5.8L) would be on the top side of the lower section of the intake manifold on the driver side. The wire attached is (I believe) red with a blue tracer. Good Luck, Kenny / MrBlueOval

1 of 1 people found this helpful.

Your Answer

Ford Bronco Experts

  • #1
    tennisshoes
    Reputation
    430
  • #2
    Js08016
    Reputation
    170
  • #2
    Clayton Cameron
    Reputation
    170
View All

Related Models For Sale

Used Ford F-150
2,153 Great Deals out of 181,813 listings starting at $1,000
Used Ford Mustang
764 Great Deals out of 42,133 listings starting at $1,300
Used Jeep Wrangler
283 Great Deals out of 15,896 listings starting at $2,997
Used Chevrolet Blazer
3 Great Deals out of 1,143 listings starting at $950
Used Ford Explorer
799 Great Deals out of 62,848 listings starting at $999
Used Ford F-250
467 listings starting at $3,490
Used Ford Ranger
167 Great Deals out of 5,505 listings starting at $1,000
Used Chevrolet Camaro
418 Great Deals out of 31,631 listings starting at $2,395
Used Toyota 4Runner
258 Great Deals out of 21,579 listings starting at $2,300

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.