I have a 1999 Silverado 1500 and it shows that it is in 4x4 but only the back tires spin. When I tried to change back to 2 it just flashes and stays in 4. The front axle is locked in and won't change.

I have a 1999 Silverado 1500 and it shows that it is in 4x4 but only the back tires spin. When I tried to change back to 2 it just flashes and stays in 4. The front axle is locked in and won't change. 1 Answer

I have a 2003 silverado 1500 4x4 . I'm having issues with it starting and have narrowed it down to behind the dash I believe . Is this known to happen in this truck? 1 Answer

It seems everything is getting power when I turn over key.. It's just dead.. not the fuses.. started wiggling around wires in column and under dash while holding key turned and it would start.. Is the...

What would it cost to replace the engine and tranny in a 2002 chevrolet Silverado 1500? 4 Answers

I have a 2002 chevrolet Silverado 1500 Z71 that I inherited when my dad passed away. The truck has 180,000 miles on it and my husband wants to sell it and put the money in a newer model with less ...

I have a 2000 silverado it has an intermittent power loss after shifting into gear. it revs just fine in park. I can pump the gas petal and in a couple of seconds its back to normal. No codes flashing 1 Answer

In park the engine revs up normally. it takes a couple of seconds pumping the gas and it starts running fine again. 1st time it happened I was towing a trailer up hill. Now the loss of power (engine...

I have a 2001 Silverado 1500 4.3 v6. I bought it used about a year ago, it throws the code "camshaft to crankshaft position correlation fault" and it has a slight miss that is worse when it's wet out. 4 Answers

I've replaced the ignition module, distributor, cap, rotor, and the crankshaft sensor. I can't figure out the problem. Could someone please help?!?