who to get a b-16a1 top dead center

Asked by May 23, 2011 at 10:53 AM about the 1991 Honda Civic CRX CRX Si

Question type: Car Customization

I have a 1991 Honda CRX Si. I motor swap so the motor is a b-16a1 head and a b-18a1 bottom end. My question is how do i make such that its top dead center to change my head gasket?

1 Answer

295

the piston that is closest to the timing belt is cylinder #1 if the head is still on the car bring the piston up on compression stroke take a long thin screwdriver and slide in down the spark plug hole and watch the travel of the handle ones the screwdriver reaches the highest point of travel on compression stroke you know ur at tdc to double check and make sure your right on compression stroke check the timing marks on the old belt to make sure there where they have to be

1 of 1 people found this helpful.

Your Answer

Add photo

Related Questions

Search Honda Civic CRX Questions

Honda Civic CRX Experts

#1 Michael Kane
Michael Kane
Reputation 60
#2 Adam Slaughter
Adam Slaughter
Reputation 50
#3 hippichic61
hippichic61
Reputation 40
View All

Related Models For Sale

Used Honda Civic
657 Great Deals out of 88,604 listings starting at $995
Used Honda Accord
812 Great Deals out of 84,287 listings starting at $1,050
Used Acura Integra
100 listings starting at $1,900
Used Honda Accord Coupe
178 Great Deals out of 10,520 listings starting at $1,995
Used Honda Prelude
115 listings starting at $3,000
Used Toyota Corolla
785 Great Deals out of 73,830 listings starting at $1,995
Used Acura NSX
297 listings starting at $156,940

Used Cars For Sale

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.