I had a massive blow put last week and not my gas guage doesn't work and my brake lights and back flashers either. I checked the ground.its nice and tight and all my fuses are good.

Asked by April Jun 05, 2014 at 05:21 PM

Question type: Maintenance & Repair

Pedal switch is good and I don't see any
loose wires. Dodge ram 1500 -2011

April answered 9 years ago

Blow out

Mark helpful

April answered 9 years ago

My drivers side front tire

Mark helpful

Your Answer:

I had a massive blow put last week and not my gas guage doesn't work and my brake lights and back flashers either. I checked the ground.its nice and tight and all my fuses are good. 2 Answers

Pedal switch is good and I don't see any loose wires. Dodge ram 1500 -2011

Dodge

-

Maintenance & Repair
I had a low beam out on my 97 dodge ramm pickup so I drove with hi-beam the whole time. Last night all lights were out and now no low or hi beam work, blinkers and rear lights work....i replace bulbs 1 Answer

after driving with only hi beam (since one of my low beam was out). I came out to find that now no headlights work at all. My blickers work and all my rear lights work. I checked the fuses and all we...

1997 Dodge RAM 1500 Laramie SLT RWD

-

Maintenance & Repair
I have 06 Dodge Ram 1500 4.7 and my brake lights doesn't work I have change Brake light and check fuses 1 Answer

When I cut the headlight on they are on have power but you push the brake down nothing happens some help please

2006 Dodge RAM 1500 SLT Quad Cab LB RWD

-

Maintenance & Repair
My tail lights on my 2010 charger stopped working. I replaced all bulbs and fuses. Still doesn't work. It doesn't happen all the time but after about 5 minutes they shut off. What's wrong with my car? 13 Answers

My Hazard lights work. Thats what I have to use when I drive at night.

2010 Dodge Charger SXT RWD

-

Maintenance & Repair
I have a 2002 Dodge Ram 1500 4x4 4.7 Sport. I recently put in a new/used motor because my old one had a bad crankshaft. So after getting new motor in I started the truck and it ran great. I only ran it for about 5 seconds because I noticed I had a broken transmission line. I went back the next day and fixed the line. I went to start the truck back up and nothing happened. No click no nothing, everything lights up on dash. My engine light comes on and blinks about tens times than stays steady. My gear selections are all lit up. Does anyone know the do it yourself solution? 1 Answer

I have a 2002 Dodge Ram 1500 4x4 4.7 Sport. I recently put in a new/used motor because my old one had a bad crankshaft. So after many hours of getting new motor in, I started the truck and it ran gr...

2002 Dodge RAM 1500 ST Quad Cab LB 4WD

-

Maintenance & Repair

Looking for a Used Dodge in your area?

CarGurus has 102,744 nationwide Dodge listings starting at $550.

Own this car?

Share your experience with others.

Write a car review

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

I had a massive blow put last week and not my gas guage doesn't work and my brake lights and back flashers either. I checked the ground.its nice and tight and all my fuses are good.

2 Answers

Your Answer:

Looking for a Used Dodge in your area?

Own this car?

Share your experience with others.

Shortcuts

Search Dodge Questions

CarGurus Experts

Know more, shop wisely

I had a massive blow put last week and not my gas guage doesn't work and my brake lights and back flashers either. I checked the ground.its nice and tight and all my fuses are good.

2 Answers

Your Answer:

Related Questions