2000 ford f - 250 v -10

Asked by May 31, 2017 at 04:14 PM

Question type: Maintenance & Repair

My transfer case will not disengage had the
acsuator replaced, then transfer case replaced
now I'm being told its the gen unit any ideas would
be appreciated thanks

4 Answers

105,485

Gem units do fail but not very often, make sure the wiring has been double checked as there is a known problem right where the transfer case harness comes through the body, it flexes right there and causes the wires to break, have seen about a dozen of these in my area, and other shops have seen them too.

Best Answer Mark helpful
105,485

Thanks for the best answer points. Hope it wasn't a GEM.

1 of 1 people found this helpful.

Nope wiring like you said but you really need to look for it, thank you so much

105,485

Yep, on some it's really obvious and on others you have to rip it completely apart and stress each indivual wire to find it or them. Glad it worked out.

Your Answer

Shortcuts

Maintenance & Repair Experts

  • #1
    Tom Demyan
    Reputation
    186,410
  • #2
    dandyoun
    Reputation
    97,340
  • #3
    tennisshoes
    Reputation
    82,530
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.