Not turning over

Asked by Jul 20, 2016 at 07:07 PM

Question type: Maintenance & Repair

02 expedition eddie bauer. The battery is fully
charged. Was running fine yesterday. Last night
got out at the store and when i returned it wouldnt
start. Checked all the connections and they are
tight. Everything comes on but wont start and
doesnt make any noise when trying to start it

5 Answers

18,810

Battery connections maybe tight but in between the terminal and the post could be dirty. Remove and clean terminals and post.

1 of 1 people found this helpful.

Did that on both terminals last night

18,810

Next thing to check is the starter tap on starter with a hammer and have someone else try to start vehicle at the same time and see if it starts. And also if you can get to the starter solenoid cross the two connections with a screwdriver and see if it will start

Tried the tapping on the starter already. Nothing happened.

18,810

What about the screwdriver thing ?

Your Answer

Add photo

Related Questions

  • Jeep not turning over 3 answers

    I need help figuring out why my jeep cranks but won't turn over.

    1997 Jeep Wrangler SE

    -

    Maintenance & Repair

  • Not turning over 4 answers

    I have tried every trick on here and it's not working, wat else could it be

    2002 Chevrolet Malibu Base

    -

    Maintenance & Repair

  • Truck Not turning over 4 answers

    My truck won't turn over. Or it has a hard time. It's a 98chevy Silverado 1500 extended cab automatic trans. Replaced spark plugs and wires but problem still persists. Checked under the hood and a ...

    1999 Chevrolet Silverado 1500 3 Dr LS 4WD Extended Cab LB

    -

    Maintenance & Repair

  • Engine not turning over 3 answers

    I connected my battery charger to the battery and being dark, for the first time in my life, I crossed the leads from the charger to the battery. When I plugged it in, I heard a "Pop". I immediately...

    2006 Ford Taurus SE

    -

    Maintenance & Repair

  • Jeep not turning over 1 answer

    I need help figuring out why my jeep cranks but won't turn over. I have replaced the crank shaft and cam shaft sensors. My ecm is new. My ASD is working. Everything is working like it should except...

    1997 Jeep Wrangler SE

    -

    Maintenance & Repair

Shortcuts

Search Maintenance & Repair Questions

Maintenance & Repair Experts

#1 Tom Demyan
Tom Demyan
Reputation 171,780
#2 dandyoun
dandyoun
Reputation 92,570
#3 tenspeed
tenspeed
Reputation 74,710
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.