- Home
- / Questions
- / Maintenance & Repair
- / I was tightening bolts inside the vacuum chamber (these bolts can be loosened, but not removed) and ...
I was tightening bolts inside the vacuum chamber (these bolts can be loosened, but not removed) and I stripped one of them. Seeing that I can't remove it, what should be done?
1 Answer
Your Answer
Related Questions
-
I was tightening bolts inside the vacuum chamber (these bolts can be loosened, but not removed) and I stripped one of them. Seeing that I can't remove it, what should be done? 1 answer
This is a 2002 Saturn Vue (V6 model)
Maintenance & Repair
-
Is it necessary to change the cylinder head bolts when replacing the head gasket? Are they strech bolts? Reason being I removed the head to fix a cracked valve and replaced the head gasket, when i started it up i was blowing white smoke, I torqued it down to proper troque and used the proper sequence. I mad sure i didnt nick the gasket when i put the head back on. I also tried tigthening the bolts more with no sucess. can any one advise? 2 answers
Is it necessary to change the cylinder head bolts when replacing the head gasket? Are they strech bolts? Reason being I removed the head to fix a cracked valve and replaced the head gasket, when i s...
2003 Honda Odyssey LX
-
Maintenance & Repair
-
I need 4 9mm 1.25" bolts for the manifold on a 1987 Toyota Pickup. I can't find them anywhere can you help me? 5 answers
My son is looking to repair his truck and we can't find anywhere that has 9mm bolts that go to the manifold. I know the truck is old but he loves it. The bolts are 1.25 and I need 4 of them. can you h...
1987 Toyota Pickup 2 Dr STD Extended Cab SB
-
Maintenance & Repair
-
I have a 2000 jeep Grand Cherokee that the Driver's side rear door is not unlocking. I have removed the entire latch and taken apart to clean and lubricate but cannot get it to "unlock" properly. There are two small springs inside the latch, one seems to be in lace but the other does not. Please help. Thank you, John C 4 answers
2000 Jeep Grand Cherokee Rear Door Latch not unlocking
2000 Jeep Grand Cherokee Limited 4WD
-
Maintenance & Repair
-
My 2008 Ford Escape AWD floor matts keep getting soaked. I thought I had fixed it by making sure the sunroof was closed properly, but it has continued. I have tried to figure out where this is coming from and finally after drying them out again I laid under the the vehicle and both on the drivers side in the middle of the front floor area and the passanger side there is a small hole about the size of a dine right in the middle. That would account for the water coming in after rain storms and such, but why would these two holes be there? Was there a drain area there with plugs and they are missing? Can I have a piece of metal welded over them? Don't know why they would be there. Doesn't seem to be a rust issue as it is frim all around these small holes. 3 answers
Water leak on floors from underneath. There is a small hole size of a dime on both drivers side and passanger side underneath floor matts right in the middle of each. Can I have this repaired with a...
2008 Ford Escape Limited 4WD
-
Maintenance & Repair
Shortcuts
- Mainenance & Repair Questions
- All Questions
- Ask a Question
Search Maintenance & Repair Questions
Maintenance & Repair Experts
-
#1Tom DemyanReputation200,580
-
#2dandyounReputation101,340
-
#3tennisshoesReputation89,120
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.