1989 Ford Probe

Asked by Jun 08, 2016 at 11:46 PM

Question type: Maintenance & Repair

Replacing the driver side cv axle half shaft.
Can't remove, is there a carrier pin to
release?

1 Answer

57,665

The axles are held in by a "C" clip inside the trany. You just have to pry the axle out.

Your Answer

Add photo

Related Questions

  • Does the NSS Switch also tell the on board computer what gear to be in and when to shift on a 1989 Probe? 1 answer

    I need a 1989 Ford Probe Specialists to answer this question. I replaced a faulty neutral safety switch on a 1968 Ford Probe (1st Generation) but the old switch had 2 plastic connectors, one with 3...

    1989 Ford Probe GL

    -

    Maintenance & Repair

  • 1989 Ford Probe

    I was driving along and all this sudden my gas pedal had no power to it so I let go and tried again and nothing. No medal hitting like pistons or rods and no belts broke. Then got it home and start...

    1989 Ford Probe GL

    -

    Maintenance & Repair

  • where is the fuel filter on a 1990 ford probe located at 1 answer

    need to know where the fuel filter is located at on the ford probe located at

    1990 Ford Probe LX

    -

    Maintenance & Repair

  • where is the TCM located in a ford probe 1 answer

    where is the TCM located in a ford probe

    1993 Ford Probe GT

    -

    Maintenance & Repair

  • 1989 ford probe gt turbo 2.2 1 answer

    starts up on cold start ,starts to warm up shuts down but still cranks, i wait for cold start ,fires right up same thing shuts down its a nice car i just bought it off the original owner that couldnt...

    1989 Ford Probe GT Turbo

    -

    Maintenance & Repair

Shortcuts

Search Maintenance & Repair Questions

Maintenance & Repair Experts

#1 Tom Demyan
Tom Demyan
Reputation 162,870
#2 FordNut
FordNut
Reputation 109,080
#3 dandyoun
dandyoun
Reputation 89,370
View All