how to bleed coolant system on 1995 pontiac grand prix

Asked by Jun 05, 2016 at 01:42 PM

Question type: Maintenance & Repair

could not get plug out of radiator to flush, so i taken bottom hose loose on my
1995 pontiac grand prix se

1 Answer

4,965

The coolant in the radiator and most of the block has already run out. You just need to crank (not start) the engine and observe any added coolant that will come out of the hose connection. Then remove the coolant from the reservoir connected to the radiator cap fitting (small dia hose). Then reconnect the hoses and fill the system. Leave the radiator cap off and bring the engine up to temp and observe coolant flow at the cap. When no air is being purged, put the cap on and pressurize the system. at temp, fill the reservoir to the "full hot" line on it and you're done.

Your Answer

Add photo

Related Questions

Shortcuts

Search Maintenance & Repair Questions

Maintenance & Repair Experts

#1 Tom Demyan
Tom Demyan
Reputation 174,950
#2 dandyoun
dandyoun
Reputation 93,540
#3 tennisshoes
tennisshoes
Reputation 76,130
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.