Wireing

Asked by Jan 22, 2016 at 02:48 PM

Question type: Maintenance & Repair

OK so I'm working on a friends 1999 Chevy blazer.
I'm putting a switch in but the connectors are to
short. What do I do?

1 Answer

237,425

You might have to properly splice for new longer wires. Use the same gauge and soldered the joints and use heat shrink.

Your Answer

Add photo

Related Questions

  • Wiring 3 answers

    On a 2005 cobalt witch of the three radiator fan wires is the ground and how to wire direct

    2005 Chevrolet Cobalt

    -

    Maintenance & Repair

  • Wiring 4 answers

    What would cause a wire in the back of the fuse box to melt it's the only melted wire I found

    1979 Chevrolet El Camino

    -

    Maintenance & Repair

  • Wireing 1 answer

    My ground wire burnt up and fried my battery and melted few wires i replaced them went to hook up battery and sparked so there are wires or a bare wire touching somewhere were would i start to loo...

    1999 Chevrolet Blazer 2 Door

    -

    Maintenance & Repair

  • Wiring 2 answers

    I'm working on a 1979 Chevrolet el camino it has shorts in it and cut wires and melted wires and just messed up wires I was replacing wires that go to the lights in the bumper and I was looking at...

    1979 Chevrolet El Camino

    -

    Maintenance & Repair

  • wires 1 answer

    what make of wires should i but for my grand national. what mm of wire

    1987 Buick Regal Grand National Turbo Coupe

    -

    Maintenance & Repair

Shortcuts

Search Maintenance & Repair Questions

Maintenance & Repair Experts

#1 Tom Demyan
Tom Demyan
Reputation 168,780
#2 dandyoun
dandyoun
Reputation 91,570
#3 tenspeed
tenspeed
Reputation 73,900
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.