Heat works great in 2010 dodge nitro, but fan fails to push the heat. Heat seeps out even with the fan on full blast.

Asked by Feb 02, 2015 at 09:44 AM

Question type: Maintenance & Repair

1 Answer

11,160

sounds like you have blend door problems in the heater ductwork

Your Answer

Add photo

Related Questions

  • Not much heat coming out 7 answers

    I don't know what to do, I've tried everything I can think of. I found and tested 3 actuator motors under the dash and the flaps they control. The motors were strong and I could not prevent them f...

    2007 Dodge Nitro SLT 4WD

    -

    Maintenance & Repair

  • Over heating and no heat 16 answers

    My fans work my hoses are hot and I have fluids and my gauge still in the red zone and no heat even on full blast just cold air I did change thermostat someone please help me

    2004 Pontiac Grand Prix GT1

    -

    Maintenance & Repair

  • over heating 2010 dodge avenger 1 answer

    My car appears to over heat, meaning the light comes on and my car shows as running hot . If I turn my heat up all the way the light turns off and the Guage needle goes back down within seconds. I...

    2010 Dodge Avenger

    -

    Maintenance & Repair

  • My Heater and Ac fan only works on High 6 answers

    When I turn my switch on for the fan on the heater and Ac it only works on full blast.

    2001 Dodge Durango Sport 4WD

    -

    Maintenance & Repair

  • Dodge nitro heat blowing cold air 28 answers

    2009 Dodge Nitro

    -

    General

Shortcuts

Search Maintenance & Repair Questions

Maintenance & Repair Experts

#1 Tom Demyan
Tom Demyan
Reputation 168,530
#2 dandyoun
dandyoun
Reputation 91,480
#3 tenspeed
tenspeed
Reputation 73,800
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.