I have a 1996 Chevrolet Z71 4X4 that will not go into gear from neutral only when turned off it will go in gear. If I start it in gear it has to forced to change gears (grinding gears).

Asked by Jan 03, 2015 at 05:30 AM

Question type: Maintenance & Repair

I have replaced the slave cylinder and is
thinking it could be the master cylinder.

1 Answer

5,085

Sounds like a bad throw out bearing since you're having problems while the engine is running

Your Answer

Add photo

Related Questions

  • my car will only shift into gear when car is off 10 answers

    I have a 1988 nissan 300zx turbo with a manual transmission. It was driving fine until I had it sitting for a few months. Now when I turn the car on it will not shift from neutral into any gear unle...

    Nissan 300ZX

    -

    Maintenance & Repair

  • my 1996 ranger goes in gear with no grinding (all gears) 10 answers

    my clutch goes to the floor easily with no pressure. It will shift into all gears and no grinding or anything. What is wrong

    Ford Ranger

    -

    Maintenance & Repair

  • Is the shifting of gears when the engine is running accomplished with grinding. 4 answers

    The clutch slave is bad. I think it needs replacing or bleeding. I am concerned that shifting into gear does not prevent the truck from moving. The truck is a 1996 ford ranger.

    1996 Ford Ranger

    -

    Maintenance & Repair

  • gear 3 answers

    Does change gears

    2004 Mazda Tribute DX 4WD

    -

    Maintenance & Repair

  • gearing 4 answers

    i have a 94 silverado with a 5.7 v8 and a 3.42 gear ratio. i want to go with a lower ratio such as a 3.73 or a 4.11.it also has an auto trans. is there any way i can find out how much this would chang...

    Chevrolet Silverado 1500

    -

    Car Customization

Shortcuts

Search Maintenance & Repair Questions

Maintenance & Repair Experts

#1 Tom Demyan
Tom Demyan
Reputation 162,880
#2 FordNut
FordNut
Reputation 109,110
#3 dandyoun
dandyoun
Reputation 89,390
View All