Have 05forenza cranks no startvcan some one point me in right detection where to start. Have spark fuel pressure is 29 psi.

Have 05forenza cranks no startvcan some one point me in right detection where to start. Have spark fuel pressure is 29 psi. 3 Answers

08 Buick Lucerne cranks but won't start have spark change fuel pump and relay but still no fuel pressure 8 Answers

I have a 08 Buick Lucerne I put a new fuel pump in it cranks but still won't start relay has been changed I have spark to the car but still no fuel pressure if anybody has any ideas please help

My 1998 Mercury Mystique 2.0 automatic cranks but wont start. Apperas to have no spark, fuel pressure is good. What could be wrong? 3 Answers

The battery is fully charged. I replaced the coil pack and the crank sensor. Would a bad cam sensor keep it from starting? Could the ignition switch be faulty even though power comes on and it cranks ...

have 1997 ford contour 2.0 reg fuel will not start have to hold pedal to the floor never did before,it tries to start but dies right away about 5-10 sec found a blown fuel pump fuse replace it also had bad wires on fuel rail they were exposed naked tape all them up.it tries to start with pedal to the floor has no codes did have 117,102po before but fixed them injectors firing,fuel pump has psi=42,node light test good on all injectors.has spark at each spark plug,good timing belt been checked still tight sprayed starter fluid in tbi will not start at then checked cam sensor has proper ohms resistance was running great till i backed up at mailbox togo into driveway replaced plugs, wires,coil pack,injectors,fuel filter before all this happeneddrove for a month then this problemall help needed i'm disable on low incom 1 Answer

have 1997 ford contour 2.0 reg fuel will not start have to hold pedal to the floor never did before,it tries to start but dies right away about 5-10 sec found a blown fuel pump fuse replace it also...

5.7 Vortec, New Fuel Pump, Has 55 PSI to the rail, New Plugs, Has Spark, Engine Cranks, No Start 9 Answers

From what I remember before my 96 K2500 wouldn't start, the codes that would show from the OBD II reader were P0301 and P0700. I believe the engine was running ok with no obvious transmission proble...