I had trouble code p2195 change O2. Then trouble code p0135 popped up on a 2004 crown victoria. I changed the oxygen sensor twice. The code popped up again. Any suggestion on why?

Asked by Dec 12, 2014 at 04:57 PM

Question type: Maintenance & Repair

2 Answers

9,890

That code may be the O2 heater fuse is open. To prevent a false reading before the engine warms up O2 sensors have a small heater that insures the Platinum wire inside will react to emission levels. The 4 wires on the sensor are +12 -12 +signal -signal the output signal is very low and varies between .3 volts to about . 9 volts and the car computer want's to see between .45 to .55 volts ( some computers will hold a tighter tolerance) .... Check the 12 volt fuses ... you may have a blown fuse

1 of 1 people found this helpful.

Ok thanks. Where us the location of the 12v fuse.

Your Answer

Add photo

Related Questions

Shortcuts

Search Maintenance & Repair Questions

Maintenance & Repair Experts

#1 Tom Demyan
Tom Demyan
Reputation 177,120
#2 dandyoun
dandyoun
Reputation 94,350
#3 tennisshoes
tennisshoes
Reputation 77,070
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.