How to make a dual 2 ohm voice coil into a 4 ohm

Asked by Aug 24, 2014 at 10:40 PM

Question type: Car Customization

Sub woofer install

1 Answer


Add a 2 ohm resistor to the circuit then measure the resistance with an ohm meter to make sure you have 4ohms.

Your Answer

Add photo

Related Questions

  • How can I do a 10k OHM mod to my car? 3 answers

    I have a 1990 Buick century and I was wondering how people do those IAC mods to trick their car into pumping more fuel and increase horsepower slightly

    1990 Buick Century Limited


    Car Customization

  • door locks, open same time with transmitter. ONE PRESS. NOT 2 3 answers

    I have asked 4 dealers, if they could program my 2004 col, to OPEN all doors with 1 press of transmitter, they said NO WAY. so I got a book on 2004 col. only. there i studied the wiring, and after a...

    2004 Chevrolet Colorado 4 Dr Z71 LS Crew Cab SB


    Car Customization

  • Can i put a sub in my car without an amp? 3 answers

    Am planning on buying the : Sony - 52W x 4 AppleĀ® iPodĀ®/Satellite Radio-Ready In-Dash CD Deck Rockford Fosgate - Punch 12" 4-Ohm Dual Subwoofers with Enclosure - Black/Silver........ do i need an amp ...

    Car Customization

  • 2000 malibu 3.1 theft system overide 1 answer

    Ohm circuit parts

    2000 Chevrolet Malibu LS


    Car Customization

  • how can i check a starter relay with a volt ohm meter 1 answer

    I need to check with a volt ohm meter, to see if the starter relay is good or not??? How can I do this with a meter.

    1996 Dodge Ram 1500 2 Dr LT 4WD Standard Cab LB




Search Car Customization Questions

Car Customization Experts

#1 Tom Demyan
Tom Demyan
Reputation 5,500
Reputation 3,460
#3 dandyoun
Reputation 3,300
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.