on my 86 mustang 4 cylinder to 302 project, I've got a 9 inch rear end out for 78 f100, I know I'd have to change out the axles, but would it fit? on the front end, change mounts n k member, what about the steering linkage? also thanks for the link to the forum

Asked by May 01, 2013 at 08:17 AM

Question type: Car Customization

1 Answer

1,170

the housing is going to be too wide. measure axle flange to axle flange to confirm this. better off to trade it for a mustang unit, K member wont be a problem with the right oilpan

Your Answer

Shortcuts

Car Customization Experts

  • #1
    Tom Demyan
    Reputation
    6,190
  • #2
    F_O_R
    Reputation
    4,390
  • #3
    COMETGUY61
    Reputation
    4,100
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.