1989 Ford 4WD F250 Range Select Lever Bolts


Asked by Aug 02, 2013 at 09:43 PM about the Ford Econoline Pickup

Question type: Maintenance & Repair

Bolts holding the Range Select Lever broke where the shift lever connects to the 4WD
shifters.  What kind of bolts does this require?

1 Answer


Grade 8 or better, they still should be available through a dealer, and remember to use BLUE locktite on the threads, that will keep them tight and stop what happened this time.

Your Answer

Add photo

Related Questions

  • 1989 f250 351 5.8 l 1 answer

    Hi I have a 1989 f250 5.8 truck that won't low idle without my foot on the pedal. Fuel pump and lines are fine checked. Has brand new distributor and cap. Plugs wires. Etc sensor, map sensor, Egr ...

    1989 Ford F-250


    Maintenance & Repair

  • Will a E4OD C6 transmission from a 1989 4WD work in the same year 2WD? 1 answer

    I have a 1989 F-250 2WD that someone put a C3 transmission in because the original went bad. I have found a rebuilt E40D, but its out of a 4WD? Is it a direct swap or at least swap with parts?

    1989 Ford F-250 STD Extended Cab LB HD


    Maintenance & Repair

  • 1989 Ford Festiva 9 answers

    I have a 1989 Ford Festiva carburated engine. It won't start. We replaced the starter and it still wouldn't start. Put a jumper on to bypass safety switch on clutch pedal & it still wouldn't sta...

    1989 Ford Festiva L


    Maintenance & Repair

  • Where is the adjusting bolt located for the distributor? 8 answers

    I have a 1987 Ford F250 4.9 in line six. I need to advance the distributor since I tuned it but can't find the adjusting bolt...HELP

    1987 Ford F-250


    Maintenance & Repair

  • Will a 94-96 ford f150 6 cylinder transmission bolt up to a 302 1 answer

    I have a 1989 ford ranger was wondering if it would bolt up to my 302 in it

    1989 Ford Ranger XLT Extended Cab 4WD SB


    Car Customization

Search Ford Econoline Pickup Questions

Ford Econoline Pickup Experts