Knock sensor ford bantam

Asked by GuruH7521 Aug 10, 2019 at 02:50 PM about the Ford Bantam

Question type: Maintenance & Repair

Hi I'm putting a spitronics PCM
management on my 1.3 ford bantam
rocam. The diagram requirements is
tdc sensor power, tdc sensor signal.  
Do I connect it to my knock sensor or
do I go for the cam sensor. And then
trigger sensor signal, trigger sensor
power. Is these two going to ignition
coil or to the injectors...?

1 Answer
16,425

Guru97FK8 answered 4 years ago

Pre 2007 the crank angle sensor requires a flywheel with 36 minus 1 tooth on the flywheel and the 2007 onwards requires a requires a flywheel with 36 minus 2 teeth. Both 1300s, new and old have knock sensors.

Mark helpful

Your Answer:

Related Questions

  • Knock sensor ford bantam 1 Answer

    Hi I'm putting a spitronics PCM management on my 1.3 ford bantam rocam. The diagram requirements is tdc sensor power, tdc sensor signal. Do I connect it to my knock sensor or do I go for the cam...

    Ford Bantam

    -

    Maintenance & Repair

  • i have a 2006 ford bantam rocam the engine has been done but when i start it it does not ref up it does not have a knock sensor and no wiring for that either 1 Answer

    i have a 2006 ford bantam rocam the engine has been done but when i start it it does not ref up it does not have a knock sensor and no wiring for that either

    Ford Bantam

    -

    Maintenance & Repair

  • ford bantam 1 Answer

    ford bantam 1.3 rocam, i have replaced the oil pump, but when the engine is hot the oil light stays on and funny noise when idling , but when the engine is cold runs smooth

    Ford Bantam

    -

    Maintenance & Repair

  • Ford bantam 1 Answer

    Hi everyone i have a 1993 model ford bantam the engin cranks but wont start can some please help me i really want to fix this problem dont know where the fuel cut off switch is located or how it l...

    1993 Ford Bantam

    -

    Maintenance & Repair

  • ford bantam 1 Answer

    Hi all my ford bantam drove perfect till i had a burst water pipe it stood for a year and i finely replaced the pipe now it wont start it cranks over but i got no spark and no fuel can anyone please...

    Ford Bantam

    -

    Maintenance & Repair

Own this car?

Share your experience with others.
Write a car review

Shortcuts

Search Ford Bantam Questions

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,120
  • #2
    Janus Welgemoed
    Reputation
    1,140
  • #3
    MrRocket12
    Reputation
    1,120
View All

Know more, shop wisely

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.