74 datsun pu how do you determine the size of the center support bearing 16mm or 22mm


Asked by Jan 23, 2015 at 07:57 PM about the Datsun 620 Pick-Up

Question type: Maintenance & Repair

there are two sizes of center support bearings 16mm and 22mm how do you know what
size to get. where do get this dimension from

2 Answers


look up the proper measurements in a shop manual- then measure the engine block and crank before and after the installation- SOP


Thanks for your answer, but i should have been more specific it is the center support bearing on the propeller shaft / drive shaft.

Your Answer

Add photo

Related Questions

  • crankshaft problems 6 answers

    got main bearings width 22mm and the crankshaft has 25mm main bearings looking for a number to order and possible crankshaft and one conecting rod for the same engine block.engine shows 7mge machine s...

    1986 Toyota Supra 2 dr Hatchback


    Maintenance & Repair

  • 99 passport 4x4 question 1 answer

    Where is the dip stick for the auto tranny and are the front bearings serviceable or have to replace them and if so, are they pressed in the knuckles

    1999 Honda Passport 4 Dr EX 4WD SUV


    Maintenance & Repair

  • Cv spindle nut 1 answer

    What size socket does it take to remove the spindle nut on a 1990 Toyota Camry le v6 .I removed it before and I seem to remember that it was a 22mm but now my socket is missing and I don't want to...

    1990 Toyota Camry LE


    Maintenance & Repair

  • removing oil sensor on 3.0L V6 AVK engine.. how? 3 answers

    We need to remove the oil pressure sensor on an Audi 3.0L V6 with an AVK engine. The sensor is located above the oil filter on the oil cooler or the oil pan facing the front of the engine (some fac...

    2003 Audi A4 3.0


    Maintenance & Repair

Search Datsun 620 Pick-Up Questions

Datsun 620 Pick-Up Experts

#1 Justin Goolsby
Justin Goolsby
Reputation 60
#2 tenspeed
Reputation 50
#3 Andrew Jennings
Andrew Jennings
Reputation 20
View All