2008 gmc sierra oil pressure drop.

Asked by Dec 28, 2016 at 12:57 PM about the GMC Sierra 1500

Question type: General

The other day I pulled into a local wing stop near my house and the oil
pressure fluctuates and goes to zero pressure and light comes on. The weird
thing is, it only does it there. No problems any where else. There is a large
radio tower near by that also affect our WI FI on phones. Am I just seeing
things or is there an issue with the oil pressure sending unit?

2 Answers

120,195

You could replace the sending unit as a test or install a mechanical gauge which would be immune to RF interference. I would check your oil level if you have not.

5

I just experienced the same thing on my 2008 Sierra 1500. It would go to approx. 35- 40 psi then within one minute it drops to zero and alarm and oil light comes on. No strange engine noises. I bought new sensor and 1 1/16" deep socket and about 4-5" extension and swivel socket. I saw on YouTube that there are two ways to go about this. One, remove intake manifold which is time consuming, or remove vacuum hose to brake booster and other end which comes in through the rear of the plastic shield. Very hard to get any tool on hose clamp at engine end of hose. Remove fuel line retainer clip that secures line then use a line release tool to remove line. Pull EGR hose out of valve cover I believe, then you can get the wire plug disconnected from sensor. It has a release tab on the firewall side of plug at the bottom of plug. Lift up and pull plug off. Put the socket with swivel and extension on sensor then ratchet. Remove then use a curved metal pick to go inside hole of sensor and carefully remove mesh screen. This was where my issue was. The screen gets clogged and sends bad sensor code. Just use brake cleaner or B12 and clean really good. Replace screen back in the hole. Remove yellow rubber washer from old sensor and put in new sensor the same way it was in the old one. Put sensor in and tighten. Don't forget to reinstall plug to sensor and just go in reverse for replacing all lines and hoses. Now I forgot the screen step and had to go through this all again. However, I thought I might try and remove the sensor without removing lines and hoses. With smaller hands this is possible. I was able to do it. My screen was dirty and clogged. After cleaning and reinstalling, light went off and pressure remains at 40-50. Sensor cost me 54.00

Your Answer:

GMC Sierra 1500 Experts

  • #1
    dragonflyoffshore
    Reputation
    5,640
  • #2
    John Saffrahn
    Reputation
    4,030
  • #3
    Glenn Clingenpeel
    Reputation
    3,800
View All

Related Models For Sale

Used Chevrolet Silverado 1500
1,837 Great Deals out of 155,600 listings starting at $1,799
Used Ford F-150
2,266 Great Deals out of 187,689 listings starting at $495
Used GMC Sierra 2500HD
126 Great Deals out of 17,498 listings starting at $2,999
Used Toyota Tundra
469 Great Deals out of 36,890 listings starting at $2,499
Used Chevrolet Silverado 2500HD
326 Great Deals out of 28,490 listings starting at $2,500
Used Ram 1500
970 Great Deals out of 129,733 listings starting at $5,695
Used Dodge Ram 1500
328 Great Deals out of 8,863 listings starting at $2,495
Used Toyota Tacoma
459 Great Deals out of 50,124 listings starting at $2,850
Used Chevrolet Tahoe
646 Great Deals out of 37,769 listings starting at $1,995
Used Ford F-250 Super Duty
424 Great Deals out of 36,233 listings starting at $1,999
Used GMC Yukon
326 Great Deals out of 23,849 listings starting at $2,000
Used Ram 2500
209 Great Deals out of 31,639 listings starting at $6,500
Used Chevrolet Colorado
270 Great Deals out of 37,150 listings starting at $1,777
Used Chevrolet Camaro
306 Great Deals out of 26,931 listings starting at $2,500
Used Jeep Grand Cherokee
1,148 Great Deals out of 80,317 listings starting at $1,500

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.