How to remove the front seat on a 1987 Chrysler 5th Avenue

Asked by Mar 19, 2015 at 07:30 PM about the 1987 Chrysler Fifth Avenue

Question type: Maintenance & Repair

1 Answer

10

The seat has 4 studs than go all the way through the floor of the car and are held in place by 4 nuts underneath the car. The electronics work via the electric plug. You may need to slide a plastic vanity cover forward thats on the inside front corner under the seat edge on the floor. Move the seat all the way forward. Under the car are 4 nuts with large attached washers located about where the four corners of the seat would be inside. The two nuts on closest to the center of the car will probably be under a thin metal flap that you need to bend down to actually get to the nut. Back off the nuts. Open the back door and lean the seat all the way forward. There is an electronic plug than needs to be released ( I used a screwdriver to push the plastic tab release). Pull the seat up. Its heavy and awkward but you can worry it out the back door.

1 people found this helpful.

Your Answer:

Chrysler Fifth Avenue Experts

  • #1
    alicat3373
    Reputation
    70
  • #2
    Ed5ubman
    Reputation
    60
  • #3
    Charlie Denbigh
    Reputation
    40
View All

Related Models For Sale

Used Toyota Camry
746 Great Deals out of 72,550 listings starting at $1,000
Used Ford Crown Victoria
736 listings starting at $3,000
Used Lincoln Town Car
29 Great Deals out of 1,455 listings starting at $1,900

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.