ls1 and the purge sensor code comes up is that why i dont get full power

35

Asked by Nov 15, 2013 at 03:12 AM about the 2004 Holden Commodore

Question type: Maintenance & Repair

lose all power when held to the floor after 10 seconds and dont have full power. purge sensor comes up as the code and the maf sensor but i changed that one and no difference also changed plugs and leads got me thinking

2 Answers

aye Australian for car, mate~?....9/10 of ALL troubles stem from one point only...that is the Ground connection from the battery to the chassis ground...over time through pulling 300 cold cranking amps or more through a single spot again and again...the dis-similar materials form a layer of "semi-conductor" corrosion...what you must do is take a Coarse wirebrush to this spot...the lug and bolt them back together for a resistance free connection that can support 300 or more cold cranking amps~.....see it matters not...these buggies are all designed with an Achilles heel...some like BMW will actually run TWO system grounds off the 1/0awg cable just to prevent this "brown out" condition from affecting critical components~

2 of 2 people found this helpful.
35

thanx mate i will give it a go and post how it went

1 of 1 people found this helpful.

Your Answer

Add photo

Related Questions

Search Holden Commodore Questions

Holden Commodore Experts

#1 Js08016
Js08016
Reputation 60
#2 Alan4444
Alan4444
Reputation 50
#2 Tom Demyan
Tom Demyan
Reputation 50
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.