I REPLACED MASTER CYLENEDR ON 88 CABROLET. BRAKES WILL NOT RELEASE COMPLETELY. I BLEAD PRESURE OFF CALAPER AND FRONT WHEEL THEN TURNS FREELY. WHEN I PRESSES BRALE PEDEL AGAIN WHEEL WAS HARD TO TURN

Asked by GALEN Jul 08, 2012 at 01:03 PM about the 1988 Volkswagen Cabriolet

Question type: Maintenance & Repair

BRAKE PROBLEM

199,785

dandyoun answered 11 years ago

Check the small rubber hoses that attach to caliper. Old hoses tend to collapse and not let the fluid to freely leave the caliper. While brakes are locked up take hose loose from caliper. Brakes should free up. Hope this helps

2 people found this helpful.

Mark helpful

Your Answer:

I REPLACED MASTER CYLENEDR ON 88 CABROLET. BRAKES WILL NOT RELEASE COMPLETELY. I BLEAD PRESURE OFF CALAPER AND FRONT WHEEL THEN TURNS FREELY. WHEN I PRESSES BRALE PEDEL AGAIN WHEEL WAS HARD TO TURN 1 Answer

BRAKE PROBLEM

1988 Volkswagen Cabriolet

-

Maintenance & Repair
hi I have vw car when I start engine everything is ok after 30 minutes driving the engine gets very hot cames smoke from engine and the oil pressure light on at idel stat and when I drive it the engine lose piwer at last it will stop 3 Answers

hi I have vw car when I start engine everything is ok after 30 minutes driving the engine gets very hot cames smoke from engine and the oil pressure light on at idel stat and when I drive it the engi...

Volkswagen Cabriolet

-

Maintenance & Repair
my cabriolet is strange. I runs great most of the time. Once in a while while driving the rpms fall below 10k and the car bogs down. It take about 45 seconds to get to 45 mph from a stop. When this happens I drive home and park the car. Upon the next start up everything is working fine. I have a new fuel filter, plugs air filter,wires, no vaccum leaks. Your thoughts on whast I could check next? Thank you 2 Answers

The car runs fine most of the time. On occassion the rpms drop below 10k and the car bogs down. It takes about 45 seconds to get up to 45 mph from a stop, I park the car in the garage and drive it aga...

1989 Volkswagen Cabriolet

-

Maintenance & Repair
1988 VW Cabriolet, after engine hot will run rough and die when acclerating 11 Answers

When engine cold I can rev to 5000 rpm and upshift and the engine will kee pulling. When hot when I rev to 5000 rpm and shift the engine dies and after a few seconds will start to run again. If the ca...

1988 Volkswagen Cabriolet

-

Maintenance & Repair
Why engine races when I srtart up? 2 Answers

When I start the car up the engine races. After the car has been sitting for years I soaked the fuel lines and distributor in Sea Foam, changed fuel pump relay and fuel injection power supply relay. T...

1985 Volkswagen Cabriolet

-

Maintenance & Repair

Own this car?

Share your experience with others.

1988 Volkswagen Cabriolet

Write a car review

Review another car

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

I REPLACED MASTER CYLENEDR ON 88 CABROLET. BRAKES WILL NOT RELEASE COMPLETELY. I BLEAD PRESURE OFF CALAPER AND FRONT WHEEL THEN TURNS FREELY. WHEN I PRESSES BRALE PEDEL AGAIN WHEEL WAS HARD TO TURN

1 Answer

Your Answer:

Own this car?

Share your experience with others.

Shortcuts

Search Volkswagen Cabriolet Questions

CarGurus Experts

Know more, shop wisely

Used Cars for Sale

I REPLACED MASTER CYLENEDR ON 88 CABROLET. BRAKES WILL NOT RELEASE COMPLETELY. I BLEAD PRESURE OFF CALAPER AND FRONT WHEEL THEN TURNS FREELY. WHEN I PRESSES BRALE PEDEL AGAIN WHEEL WAS HARD TO TURN

1 Answer

Your Answer:

Related Questions