My check engine light came on in my 2007 Dodge Ram 1500 5.7L Hemi and when i had it scanned it said Ehaust Gas Recirculation Sensor A Circuit High....what does that MEAN??

My check engine light came on in my 2007 Dodge Ram 1500 5.7L Hemi and when i had it scanned it said Ehaust Gas Recirculation Sensor A Circuit High....what does that MEAN?? 3 answers

my dodge 2007 1500 5.7 hemi check engine light come on a stating oil pressure pump... replace both sensor and check engine light on again.. where do i go from here? 2 answers

replaced both sensors,light still come on

My 96 dodge ram 1500 hasn't been starting in the cold unless I hold my foot a on the gas and get my temperature gauge up then it finally idles but I don't know what the problem is. 1 answer

My 96 dodge ram 1500 hasn't been starting in the cold unless I hold my foot a on the gas and get my temperature gauge up then it finally idles but I don't know what the problem is. It drives fine ...

I have a 2007 Dodge Ram 1500 SLT with the 4.7. The plugs for the 4.7 have a reach of 3/4". I believe my mechanic may have installed the plugs for the 5.7 hemi which are 1" in reach. My truck went into the shop perfectly fine and came out with the engine knocking. Is it possible that the 1/4" difference in length caused the pistons to strike the longer, incorrect plugs hence, that caused the knock? The shop admitted to me that the wrong plugs had been ordered. When asked if it was possible that they may have installed the incorrect ones, they told me that the thread size wasn't the same. Well, truth be told, it is the same size thread. Thanks for any input! 2 answers

The plugs for the 4.7 have a reach of 3/4". I believe my mechanic may have installed the plugs for the 5.7 hemi which are 1" in reach. My truck went into the shop perfectly fine and came out with th...

I have a 2002 Dodge Ram 1500 4x4 4.7 Sport. I recently put in a new/used motor because my old one had a bad crankshaft. So after getting new motor in I started the truck and it ran great. I only ran it for about 5 seconds because I noticed I had a broken transmission line. I went back the next day and fixed the line. I went to start the truck back up and nothing happened. No click no nothing, everything lights up on dash. My engine light comes on and blinks about tens times than stays steady. My gear selections are all lit up. Does anyone know the do it yourself solution? 1 answer

I have a 2002 Dodge Ram 1500 4x4 4.7 Sport. I recently put in a new/used motor because my old one had a bad crankshaft. So after many hours of getting new motor in, I started the truck and it ran gr...