Drive dodge ram 1500 Hemi 5.7, Having issues where I place truck in drive and press gas and truck just rev's for about 20-40 sec's then goes. In reverse I dont seem to have that same problem. Whats g

Drive dodge ram 1500 Hemi 5.7, Having issues where I place truck in drive and press gas and truck just rev's for about 20-40 sec's then goes. In reverse I dont seem to have that same problem. Whats g 1 answer

Dodge ram 1500 5.7 ...truck idling fine when first start in the morning but when I put it on drive and press on gas pedal its not runing good...like miss fire or something... 3 answers

And this problem only last for a few sec.

I recently purchased a 2004 Dodge Ram 1500 pick up. It has an Awesome ride and appearance. My father owned it and used it mainly for stuff to do the yard, mulch, sand, etc. I am just wondering now that I drive it daily to work should I switch oils to a synthetic to keep the engine at its prime? I have no issues with this truck, just want to keep her driving excellent. Can anyone make some suggestions please? 1 answer

V-8 Hemi , 4 door.

I have a 1997 Dodge Ram 1500. The truck is in great condition, with very low mileage. I have recently started having a problem where the truck will stall when I take my foot off the gas pedal. 1 answer

I have run a diagnostic code check with my ODBII reader and have gotten no codes. Vacuum is good, changed spark plugs and there are no signs of sludge, burnt oil, bad fuel/air mixture, or bad fuel. ...

I have a 2007 Dodge Ram 1500 SLT with the 4.7. The plugs for the 4.7 have a reach of 3/4". I believe my mechanic may have installed the plugs for the 5.7 hemi which are 1" in reach. My truck went into the shop perfectly fine and came out with the engine knocking. Is it possible that the 1/4" difference in length caused the pistons to strike the longer, incorrect plugs hence, that caused the knock? The shop admitted to me that the wrong plugs had been ordered. When asked if it was possible that they may have installed the incorrect ones, they told me that the thread size wasn't the same. Well, truth be told, it is the same size thread. Thanks for any input! 2 answers

The plugs for the 4.7 have a reach of 3/4". I believe my mechanic may have installed the plugs for the 5.7 hemi which are 1" in reach. My truck went into the shop perfectly fine and came out with th...