Im having trouble starting a 2002 Ford F150 Truck 5.4L 8 cycliner alternate fuel trinitron. The motor turns but it seems like there is no gas going to the motor. So what could be my problem?

Im having trouble starting a 2002 Ford F150 Truck 5.4L 8 cycliner alternate fuel trinitron. The motor turns but it seems like there is no gas going to the motor. So what could be my problem? 1 answer

my 1997 ford f150 turns off when im on a stop light .. what could be the problem??? 1 answer

my f150 turns off when im stopped at a stop light.. whta could be the problem??

i have a 92 ford F-150 iam having trouble with the back tank ok it leaked so i had it replaced recently along with side tank but the problem is the the side works fine but the back will work for about i say 20 min then it acts like it starvin for gas shakes the truck then dies but if u catch it b4 it dies like switch to side tank it will comm out of it think it may b just a fuel filter it looks a little wet like getting too much gas iam at a loss suggestions? 1 answer

got two new tanks on it side works fine but when i switch to back it takes about twenty minutes then truck shakes acts like not getting gas but if u catch it before it dies and switch to side tank it ...

I have a 1991 Ford F150 Lariat XLT. I replaced the fuel lines & installed a new fuel pump. The engine turns over but it won't crank. What could be wrong with my truck? 3 answers

The engine is getting gas but it won't crank. I replaced the fuel lines & fuel pump but I'm still having the same problem

I have a 1977 ford f150 with a 351 engine in it. It dies sometimes and has trouble starting again, as if fuel isnt getting to the carborator. I have replaced the tank,fuel pump, fuel filter at engine and behind pump. what could be the problem? I am a frustrated 17 year old wanting to know how to fix his truck 5 answers

It dies sometime and has trouble starting. I have replaced the fuel tank, fuel pump, fuel filters behind pump and on engine. as if no fuel is reaching the carborater but when i check if lines are push...