Do you need to lengthen the drive shafts for a 4 inch lift kit? 72 suburban

Asked by Nov 09, 2013 at 08:40 AM about the 1972 Chevrolet Suburban

Question type: Car Customization

3 Answers

1,435

No you wont have to buy new driveshafts if you have a slip yoke but make sure when you install it to check the angle of the pinion to transmission to make sure it will not bind if it does bind you can buy blocks to tilt the axle so that it wont bind

1 of 1 people found this helpful.
16,465

You need to use a shaft stretcher. The transmission goes up in the air higher but the rear end stays stationary. If you can get a longer yoke it may work, but go to a transmission shop to have them stretch your shaft.

240

ron at miestro moffler and driveshgaft you need to see where the seal rides on the yolk if more than 2 inchs retube the driveshaft also if you put blocks or springs efects the position of yolk compressed 1/2 in from seal with springs if blocks your still hitting the stops call me 602 997 0906

Your Answer

Suburban

Looking for a Used Suburban in your area?

CarGurus has 25,280 nationwide Suburban listings starting at $1,799.

ZIP:

Chevrolet Suburban Experts

  • #1
    Andrew Olsen
    Reputation
    1,060
  • #2
    Neal Turner
    Reputation
    940
  • #3
    Eric Fritz
    Reputation
    920
View All

Used Cars For Sale

2017 Chevrolet Suburban For Sale
124 Great Deals out of 9,088 listings starting at $39,608
2016 Chevrolet Suburban For Sale
54 Great Deals out of 1,598 listings starting at $30,500
2015 Chevrolet Suburban For Sale
57 Great Deals out of 1,784 listings starting at $22,997
2014 Chevrolet Suburban For Sale
36 Great Deals out of 601 listings starting at $15,900
2013 Chevrolet Suburban For Sale
31 Great Deals out of 682 listings starting at $13,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.