Fuel pomp installation

Asked by May 06, 2013 at 10:45 PM about the 1976 Chevrolet Blazer

Question type: General

2 Answers

100,705

That should be a mechanical pump on the side of the engine. Takes a couple of bolts and treat it to a new piece of fuel line.

1,150

its on the right front of the engine.theres a rod that goes thru the block to the cam. the rod pushes on the pump arm. chances are the rod is going to slid down when you pull the pump. you can use a old butter knife to hold the rod upwhile changing the pump. it will go a lot easier if you use a little contact cement on the gasket, or you can silicone it

Your Answer

Chevrolet Blazer Experts

  • #1
    Andrew Olsen
    Reputation
    2,030
  • #2
    yetilikesbeer
    Reputation
    1,350
  • #3
    Rowefast
    Reputation
    1,030
View All

Related Models For Sale

Used GMC Jimmy
237 listings starting at $1,300
Used Ford Bronco
194 listings
Used Chevrolet Suburban
350 Great Deals out of 21,943 listings starting at $1,999
Used Chevrolet Camaro
416 Great Deals out of 30,918 listings starting at $3,550
Used Ford F-150
2,317 Great Deals out of 184,576 listings starting at $699
Used Jeep Cherokee
380 Great Deals out of 47,896 listings starting at $2,795

Used Cars For Sale

2005 Chevrolet Blazer For Sale
13 listings starting at $2,995
2004 Chevrolet Blazer For Sale
109 listings starting at $2,250
2002 Chevrolet Blazer For Sale
138 listings starting at $2,595
2001 Chevrolet Blazer For Sale
123 listings starting at $2,495

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.