does a 351cleveland fit a 1970 fastback mach 1

Asked by Oct 30, 2014 at 11:12 PM about the 1970 Ford Mustang

Question type: General

Was told a Windsor and Cleveland don't fit all models of mustangs

2 Answers


you can put a small or a big block, in a 1970 small 260/289/302/351w to a 351c/390/427/428/429/460

For 1970, Ford put either engine in the cars on the assembly line. The plant determined which engine and consequently which pieces needed to finish assembly. Unless it was special ordered a certain way.Dimensionally, they aren't much different. The motor mounts and bellhousing holes all line up.The flywheel for the specific engine must be used,as the radiator and hoses. Also, the engine wiring harness for the corresponding engine must be used. A complete donor engine with all accessory brackets makes it a breeze,unless you plan on a new serpentine-type system. Hope this helps!! Good luck!

Your Answer

Ford Mustang Experts

  • #1
    Tom Demyan
  • #2
  • #3
    Bob Beaman
View All

Related Models For Sale

Used Chevrolet Camaro
252 Great Deals out of 29,972 listings starting at $4,980
Used Dodge Challenger
120 Great Deals out of 25,237 listings starting at $7,250
Used Dodge Charger
240 Great Deals out of 32,992 listings starting at $495
Used Chevrolet Corvette
93 Great Deals out of 15,649 listings starting at $4,500

Used Cars For Sale

2018 Ford Mustang For Sale
15,533 listings starting at $19,999
2017 Ford Mustang For Sale
65 Great Deals out of 7,323 listings starting at $15,657
2016 Ford Mustang For Sale
30 Great Deals out of 2,244 listings starting at $12,391
2015 Ford Mustang For Sale
24 Great Deals out of 2,177 listings starting at $12,000
2014 Ford Mustang For Sale
30 Great Deals out of 1,871 listings starting at $8,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.