Fuze keeps going out when o replace it car won't start now. Ignition fuze

Asked by Apr 22, 2015 at 10:30 AM about the 2000 Plymouth Breeze

Question type: Maintenance & Repair

1 Answer


Fuse blowing,might be bad igintion switch,or the stater is bad.

Your Answer

Add photo

Related Questions

  • Fuze keeps going out when o replace it car won't start now. Ignition fuze 1 answer

    2000 Plymouth Breeze


    Maintenance & Repair

  • my car wont even turn over to start can u help 13 answers

    i repaired plug ,wires ,coil pack . now i had to disconnect the battery so it wont go dead . then i went out to start it and it wont turn over and the wipers ,radio,turn signals, wont work check all...

    1998 Plymouth Breeze


    Maintenance & Repair

  • Why won't my ignition key turn off on my 1999 my Plymouth breeze 1 answer

    Car key stays on and my battery runs dead over night

    1999 Plymouth Breeze


    Maintenance & Repair

  • 99 Plymouth Breeze won't crank, help? 10 answers

    99 Plymouth Breeze. Will turn over and run for a few seconds, then sputters a few times and dies. I can hear the fuel pump hum when I turn on the battery, so I assume it's working. What else would i...

    1999 Plymouth Breeze 4 Dr STD Sedan


    Maintenance & Repair

  • Car won't start 2 answers

    I'm trying to help a friend with her car not starting. When trying to jumpstart the car, the battery cables get very hot and start to smoke. What will cause the cables to do this? I was pointing towa...

    1998 Plymouth Breeze 4 Dr Expresso Sedan


    Maintenance & Repair

Search Plymouth Breeze Questions

Plymouth Breeze Experts

#1 jecra
Reputation 250
#1 Andrew Olsen
Andrew Olsen
Reputation 250
#3 Tom Demyan
Tom Demyan
Reputation 160
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.