cannot get brakes after bleeding 3 times, would this have anything to do with proportioning valve on rear of truck

Asked by Feb 27, 2007 at 11:14 AM about the 1991 Nissan King Cab

Question type: Maintenance & Repair

customer had a brake pipe rot off and was repaired.  I have tried for 3 days to get brakes.  They are fine for a bit then loose pedal.  One bleeder screw i cannot get loose, afraid of twisting it off.  I have replaced master cylinder as well.  The pads are fine.   email   bp    thank you !!

1 Answer


The air remaining in the brake system is probably trapped in the line/wheel cylinder from which ou can't remeove the bleeder valve. Suggest you use some strong penetrating oil on the stuck bleeder valve, tap with a brass hammer and try to remove it so you can do a complete bleed job. Cheers 53poor

1 people found this helpful.

Your Answer

Nissan King Cab Experts

  • #1
  • #2
    Chad Starling
  • #2
View All

Related Models For Sale

Used Nissan Truck
80 listings
Used Nissan Pickup
8 listings
Used Ford F-150
2,344 Great Deals out of 215,477 listings starting at $1,300
Used Chevrolet S-10
10 Great Deals out of 957 listings starting at $950
Used GMC Sierra 1500
722 Great Deals out of 58,462 listings starting at $1,900
Used Nissan Skyline
6 listings
Used Toyota Pickup
106 listings starting at $2,995
Used Honda Civic
333 Great Deals out of 52,980 listings starting at $1,200
Used Mazda B-Series Pickup
3 Great Deals out of 138 listings starting at $1,350

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.