94 grand cherokee wont start
Asked by goodfellow57 Dec 19, 2010 at 06:14 PM about the 1994 Jeep Grand Cherokee
Question type: Maintenance & Repair
94 g c stalled wait a while it would start but then stall again fuel good was told it was ecm
box replaced with used one still wont start replaced with a 2nd used one still wont start now
has no spark from coil and check wires going into the coil no power,
5 Answers
Does your jeep have a security system . If so look no further... if activated it will start and stall as soon as you release the key from start position to run position. »Hope this tip is useful.
hammerhead2011 answered 14 years ago
my 93 is doing the same thing, did you ever get this solved? If so what did you have to do? Was it in the security sytem?
you need to replace the cam/crank sensor on your jeeps. it is about 50-75 bucks. located on the top of the transmission drivers side right at where the bell housing meets the engine. it controls your fuel, spark, coil, and ecm.
My 1994 jeep grand Cherokee has all of these problems it is the cam/crank sensor now I just gotta I figure out what bolt pattern it is.
If any one help me out that would be cool..
