misfire in no#1 cylinder, have already changed "all" plugs...still getting misfire
Ok, so now that you changed the plugs, your onto replacing the ignition coil on Cylinder #1. That's the part that sits on top of the spark plug.
Most misfires in Dodge/Chrysler vehicles are caused one of the four: Spark plugs, ignition coils, fuel injectors or hydraulic lifters and rocker arms. My experience with these vehicles show that your must run your diagnostics in the following order. Check the spark on each spark plug. If all spark plugs have a spark, then this eliminates spark plugs and ignition coils. However, if one spark plug does not spark, then swap its position with a known working spark plug. If swapping shows the working spark plug gets the spark, then change the defective spark plug, otherwise if the swapped working spark plug does not spark, then it is the ignition coil that needs to be changed. If all sparks plugs and ignition coils are working perfectly, then the next move is to shift positions of the injector from one of the misfiring cylinder with an injector with a firing cylinder. If the misfire moves with the injector, then the answer is obvious, however if the misfire remains on the same cylinder then you have to open the valve cover and inspect the valve lifters, one of them my be dead or one of the rocker arms to the cylinder may have flown off
So if swapings pluggs and or coil and the problem stays on cyl. #1 but the problem (loss of power, engine shakes and hesitates) comes and goes. Would that eliminate being a valve lifter? If so, then we change out the injector? If so, would you recommend changing all or that one? OEM part or other performance brand? Thanks.
Looking for a Used 300 in your area?
CarGurus has 19,459 nationwide 300 listings starting at $1,400.
Search Chrysler 300 Questions
Chrysler 300 Experts
Related Models For Sale
Used Cars For Sale