egr circuit code ,350 engine gmc,sierra,bogs down when let off gas,any idea or similar problem

egr circuit code ,350 engine gmc,sierra,bogs down when let off gas,any idea or similar problem 2 Answers

i have a 92 gmc sierra 5 speed manual and when i let off gas out side and inside lights dim very low almost off and radio cuts off what is my problem 3 Answers

i have a 92 gmc sierra 5 speed manual and when i let off gas out side and inside lights dim very low almost off and radio cuts off what is my problem

1990 gmc sierra k1500 5.7 350 2 Answers

My 1990 gmc sierra k1500 5.7 350 will crank and idle great and Rev fine and you can put it in gear and drive it somewhat fine but occasionally it sputters and cuts off and when you mat the gas ped...

2014 gmc sierra Engine Oil Solenoid valve stuck off 1 Answer

my 2014 GMC Sierra has a check engine light on. The code comes up as "Engine Oil Pressure Control Solenoid Valve Stuck off." I heard this is a common problem and a potential potential error that the...

04 gmc sierra 1500 5.3 died on me on the highway got it towed home starting going at it, hooked two different scanners to it and not throwing any codes (ecm is working bc the map was reading correctly but also the rpm was zero) anyways checked fire none checked injectors they wasnt working either(built fuel pressure then unplugged fuel relay then turned engine over and the pressure stayed the exact same) i assume it might be the crank sensor but i would think it would throw a code, anyways came back this morning and before doing anything for the hell of it i checked the gas cap and tightened it and it fired up perfect three different times and the last time i let it run and it died after bout 45 seconds (fuel pressure reads 55) and after it died its doing the same thing cranks but wont fire or start 1 Answer

died on me on the highway got it towed home starting going at it, hooked two different scanners to it and not throwing any codes (ecm is working bc the map was reading correctly but also the rpm was...