Have a bad engine valve would it make matters worse to change oil I was told it may

Have a bad engine valve would it make matters worse to change oil I was told it may 2 Answers

At first, the belt went and so I replaced that, then my son drove it and the compressor froze and has never started since. He drove it to my drive and there it died. So I had to replace the compressor and then it did not even turn over it was completely dead. The battery is only 2 months old. So then I went to the started. One replaced it did turn over. I then got a computer from Autozone and the code said the alternator and that is why I replaced it. So again it only turns but no ignition. So that is why I checked the plugs and the fuel pump because there is no fire. But the fuel pump is pumping fuel. So all the parts have been replaced as a process. I am now reaching 2 Answers

At first, the belt went and so I replaced that, then my son drove it and the compressor froze and has never started since. He drove it to my drive and there it died. So I had to replace the compress...

At first, the belt went and so I replaced that, then my son drove it and the compressor froze and has never started since. He drove it to my drive and there it died. So I had to replace the compress 1 Answer

At first, the belt went and so I replaced that, then my son drove it and the compressor froze and has never started since. He drove it to my drive and there it died. So I had to replace the compress...

Engine Dies When Accelerating too Quickly 1 Answer

6 months ago, I was driving down the highway at 70mph when there was a slight jerk in my steering wheel towards the driver's side, the RPM gauge went out and the check engine light came on. I made ...

I need to know how can I get to the in-line fuse for the factory radio in a 2011 Kia Forte? I pulled the side panels off that are under the dash and on each side of the console the front of the cont.d 1 Answer

Automatic gear handle.one orange wire so tight I couldn't get any slack...tried removing radio can't get the face plate off.any ideas would b appreciated. I have no radio.need to change in-line ...