How do I remove front signal lens covers from a 2012 jeep liberty. Full of water
1 Answer
Dannyl answered 2 years ago
Newer light repairs include removal of that whole light pod, then take it to the bench. the clips and fasteners install it from behind. you may need picks or strange pliers or long reach tools, perhaps. The arrangement is like the germans started doing in the 1980's. You remove it as a module, service it, then reinstall it, replace a mess of hardware and or clips sometimes to keep it installed and aligned correctly.
Your Answer
Related Questions
-
How do I remove front signal lens covers from a 2012 jeep liberty. Full of water 1 answer
2012 Jeep Liberty
-
General
-
tires for a jeep liberty sport 2003 2 answers
in my car manual my tire size states P195 70R14, the size of tires i have been using on my jeep for 5 yrs is P215 75R16 ( 2 are old and 2 new replaced at dealer) i have the opportunity to by 4 ne...
Jeep Liberty
-
General
-
06 jeep liberty 4wd 1 answer
how do I put my jep in nut. so I can pull behind motorhome
2006 Jeep Liberty Limited 4WD
-
General
-
2006 Jeep Liberty Fuel Door Question 3 answers
I recently bought a used 2006 Jeep Liberty. After about a week, when I had to fill it up with fuel, I noticed that the little metal "flap" just inside the filler neck wasn't there like it is in most ...
2006 Jeep Liberty
-
General
-
Jeep liberty problems with engine misfires 2 answers
It seems to me this issue is a very serious problem with COUNTLESS jeep liberty models and they should be on national recall to fix this serious issue because driving them on the roadways is dang...
Jeep Liberty
-
General
Shortcuts
Search Jeep Liberty Questions
Jeep Liberty Experts
-
#1fixmyjeepReputation1,550
-
#2rst429Reputation1,270
-
#2Tom DemyanReputation1,270
Related Models For Sale
Used Cars For Sale
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.