my 2005 GMC z71 would blink in 4wd and would go rite back into 2wd
it would eventually go in after I drove it 20 miles or so, but it now does not at all blink in 4wd and a service 4wd message has appeared I have checked the switch and ive replaced the actuator none of them solved the problem please help
This has a module in behind the switch for the 4x4. I have replaced several for this concern. You will have to take it out and match the # to get a new one.
it will be behind the push buttons for the 4wd I the cab?
Is your push button on drivers side on the left of dash?
driver side. has auto 2wd, 4wd hi, 4wd low, in that order.
Yes,pull the switch and it is in behind down inside.It can be a bugger to change.
alright well I just polled my whole dash apart on the driver side and all I could see was an empty space I didn't see any modules
They have moved it then. Let me check and I'LL GET BACK.
ide appreciate that thank you, what does the module do anyway
It is still there in the same spot but hard to see. Crawl under the dash and look back UP towards the firewall.It's not very big. It receives signal from the switch to engage the transfer motor.
is it possible to show a picture because I just got under the dash and there was a lot of wires and stuff lol and I tried to fallow the wires from the switch to the wherever but I couldn't find anything
It is there, just harder than heck to see and get to. Look down in the dash on the left side and you can see just the edge of it.Look towards the door but down in the dash.
is it close to the fuse box inside the truck
ok im going to check it in the morning I appreciate all your help
Looking for a Used Sierra 1500 in your area?
CarGurus has 56,419 nationwide Sierra 1500 listings starting at $2,400.
Search GMC Sierra 1500 Questions
GMC Sierra 1500 Experts