Bantam 2007 1.6 rocam will not start

Asked by Jul 21, 2019 at 06:45 AM about the 2007 Ford Bantam

Question type: Maintenance & Repair

I have spark, fuel pressure and engine cranks. I
have swapped starter relay. Fuel pump inertia
switch has been disconnected and bridged. Tested
the NTC temp sensor. All is working as it should.
Any suggestions wouls be appreciated.

2 Answers


Spark,fuel and it cranks but no start correct??


Check the main starter cable amperage draw. If the Amperage Draw is too high, it will crank but not start. Have you fitted another engine ? You must have the original flywheel for your vehicle on the engine. Your engine has 36 minus 2 teeth for the crank angle toothed rotor, and the older ones have 36 minus 1 teeth.

Your Answer:

Ford Bantam Experts

  • #1
  • #2
    Janus Welgemoed
  • #3
    AB Zaviour
View All

Find great deals from top-rated dealersTM


Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.