1300Rocam won't start. After returning from holiday had to jump start the engine . Drove around the whole whole day without any starting problems. Next morning it would not start. There is no spark.

Asked by Apr 18, 2017 at 03:13 AM about the 2006 Ford Bantam

Question type: Maintenance & Repair

2 Answers

113,605

HAVE YOU CHECKED TO SEE WHAT THE VOLTAGE IS ON THE BATTERY, DID IT GO DEAD AGAIN. IS YOUR ALTERNATOR WORKING ?

225

Could possibly be the ECU/PCM. Sounds like the vehicle was jump started incorrectly. If there was no spark, Check the starter relay, it could have short circuited. In this case there will be no spark.

Your Answer

Ford Bantam Experts

  • #1
    Janus Welgemoed
    Reputation
    630
  • #2
    Joel Mearns
    Reputation
    560
  • #3
    AB Zaviour
    Reputation
    490
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.