Hi all my 2004 1.8 diesel bantams rev counter wont work any ideas?

Asked by Jan 14, 2017 at 11:16 PM about the 2004 Ford Bantam

Question type: Maintenance & Repair

2 Answers

Found out if you have a big short electrically the needle can swing all the way round and end up under the stopper. Some say just remove the clocks and swing it around manually

215

Perform a cluster check. Ignition off, Cluster trip button in and hold it there, Switch the ignition to ON and hold the button in until the ODO display shows TEST. Release the trrip button and press again. The Speedo will go to full sweep. Press the button again and the RPM will also go to full sweep. If this is working check the main cluster wire from the PCM to the cluster. Check also the crank angle sensor plug by the flywheel. and check this harness

Your Answer

Ford Bantam Experts

  • #1
    Janus Welgemoed
    Reputation
    630
  • #2
    Joel Mearns
    Reputation
    560
  • #3
    AB Zaviour
    Reputation
    490
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.